Terminals Of Ecu
- CHECK CLOCK
- Disconnect the L38 clock connector.
- Measure the resistance and voltage according to the value(s) in the table below.TERMINALS SPECIFIED CONDITION
Terminal No. (Symbols) Wiring Color Terminal Description Condition Specified Condition L38-7 (E) - Body ground B - Body ground Ground Always Below 1 Ω L38-8 (B) - L38-7 (E) R - B Battery Always 11 to 14 V L38-4 (ACC) - L38-7 (E) LG - B ACC power supply Engine switch on (ACC) 11 to 14 V If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the L38 clock connector.
- Measure the voltage according to the value(s) in the table below.TERMINALS SPECIFIED CONDITION
Terminal No. (Symbols) Wiring Color Terminal Description Condition Specified Condition L38-3 (ILL-) - L38-7 (E) LG - B Illumination signal Light control switch OFF Below 1 V L38-3 (ILL-) - L38-7 (E) LG - B Illumination signal Light control switch TAIL 11 to 14 V L38-5 (TX-1) - L38-7 (E) R - B AVC-LAN communication signal Engine switch on (ACC) 2 to 3 V L38-6 (TX+1) - L38-7 (E) G - B AVC-LAN communication signal Engine switch on (ACC) 2 to 3 V If the result is not as specified, the clock may have a malfunction.
- CHECK DISPLAY AND NAVIGATION ASSEMBLY (w/ Navigation System (for HDD)) (see TERMINALS OF ECU )
- CHECK MULTI-DISPLAY (w/ Navigation System (for DVD)) (see TERMINALS OF ECU )
- CHECK MULTI-DISPLAY (w/o Navigation System) (see TERMINALS OF ECU )