LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting >> Smart Access System With Push-Button Start >> DTC B2281 "P" Signal Malfunction >> Inspection Procedure

Inspection Procedure

  1. INSPECT SHIFT LOCK CONTROL ECU 
    1. Disconnect the K39 ECU connector.
    2. Measure the resistance of the ECU.

      Standard resistance 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      11 (P2) - 8 (E) Shift lever position in P 10 kΩ or higher
      11 (P2) - 8 (E) Shift lever position other than P Below 1 Ω
    3. Fig 1: Identifying Shift Lock Control ECU Connector Terminal
      G05303632Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG:  GO TO SHIFT LOCK SYSTEM

    OK: GO TO Next Step 

  2. CHECK WIRE HARNESS (POWER SOURCE CONTROL ECU - SHIFT LOCK CONTROL ECU) 
    1. Disconnect the K73 ECU connector.
    2. Disconnect the K39 ECU connector.
    3. Measure the resistance of the wire harness side connectors.

      Standard resistance 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Specified Condition
      K73-5 (P) - K39-11 (P2) Below 1 Ω
      K73-5 (P) or K39-11 (P2) - Body ground 10 kΩ or higher
    4. Fig 2: Identifying Power Source Control ECU And Shift Lock Control ECU Connector
      G05303633Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO Next Step 

  3. READ VALUE OF INTELLIGENT TESTER (SHIFT P SIGNAL) 
    1. Check the DATA LIST for proper functioning of the shift position signal.

      Power source control ECU 

      POWER SOURCE CONTROL ECU - DATA LIST REFERENCE

      Item Measurement Item / Display (Range) Normal Condition
      SHIFT P SIG Shift position signal / ON or OFF ON: Shift position is P
      OFF: Shift position is not P

      OK: ON (shift position is P) appears on screen. 

    NG:  GO TO HYBRID CONTROL SYSTEM

    OK: REPLACE POWER SOURCE CONTROL ECU