Brake Control Warning Light does not Come ON: Wiring Diagram
(See WIRING DIAGRAM ).
- INSPECT CAN COMMUNICATION SYSTEM
- Check if the CAN communication system DTC is output (See HOW TO PROCEED WITH TROUBLESHOOTING
).
Result
RESULT REFERENCECondition Proceed to DTC is not output A DTC is output B
B : REPAIR CAN COMMUNICATION SYSTEM
A : GO TO NEXT STEP
- Check if the CAN communication system DTC is output (See HOW TO PROCEED WITH TROUBLESHOOTING
).
- INSPECT MULTIPLEX COMMUNICATION SYSTEM
- Check if the multiplex communication system DTC is output (See
DIAGNOSIS SYSTEM
).
Result
RESULT REFERENCECondition Proceed to DTC is not output A DTC is output B
B : REPAIR MULTIPLEX COMMUNICATION SYSTEM
A : GO TO NEXT STEP
- Check if the multiplex communication system DTC is output (See
DIAGNOSIS SYSTEM
).
- INSPECT BRAKE CONTROL WARNING LIGHT
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch on.
- Select the "ECB WARN LAMP" in the ACTIVE TEST and operate the brake control warning light by the intelligent tester.
ABS / VSC / TRAC:
ABS / VSC / TRAC ITEMItem (Display) Vehicle Condition/ Test Details Diagnostic Note ECB WARN LAMP Turns brake control warning light ON/OFF Observe combination meter - Check that "ON" and "OFF" of the brake control warning lights are indicated on the combination meter when using the intelligent tester.
OK: The brake control warning lights turn on or off in accordance with the operation using the intelligent tester.
HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE ).
NG : Go to step 4
OK : REPLACE SKID CONTROL ECU
- INSPECT COMBINATION METER ASSEMBLY
- Check the combination meter assembly (See HOW TO PROCEED WITH TROUBLESHOOTING
).
HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE ).
NG : REPLACE COMBINATION METER ASSEMBLY
OK : END
- Check the combination meter assembly (See HOW TO PROCEED WITH TROUBLESHOOTING
).