LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Engine Control System (4GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation) >> ECM >> Installation

Section 25 (Engine Control System (4GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation): ECM: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ECM 
    1. Install the ECM to the ECM box.
      NOTE:
      • Install the ECM on the ECM box with the name plate facing the inside of the vehicle.
      • Make sure that there is no foreign matter on the gasket surface of the ECM box.
      • Insert the stud bolt on the vehicle rear side to the ECM first.
      • Make sure that stud bolts are securely installed into the front and rear bolt holes.
      Fig 1: Installing ECM To ECM Box
      G04043964Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 nuts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

      NOTE: Be sure to first tighten the nut on the vehicle rear.
    3. Connect the ECM connectors.
      1. Connect the 6 ECM connectors.
        NOTE: Be sure to securely connect the connector.
      2. Connect the connector holder to the ECM box.
      Fig 2: Identifying ECM Nuts
      G04043965Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ECM COVER 
    1. Install the ECM cover with the 3 bolts.

    Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

    NOTE: Make sure that the wire harness does not get caught between the parts.
    Fig 3: Identifying ECM Cover Bolts
    G04043966Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL ENGINE ROOM SIDE COVER LH (See  INSTALLATION  ) 
  4. INSTALL COOL AIR INTAKE DUCT SEAL (See  INSTALLATION  )