LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission (A760H)) >> Shift Lever Assembly >> Installation

Shift Lever Assembly: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY 
    1. Install the floor shift assembly with the 4 bolts.

      Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf) 

    2. Connect the connector to the floor shift assembly.
    Fig 1: Connecting Connector To Floor Shift Assembly
    G04045334Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Install the floor shift gear shifting rod sub-assembly with the nut.

    Torque: 13 N*m (133 kgf*cm, 9 ft.*lbf) 

    Fig 2: Installing Floor Shift Gear Shifting Rod Sub-Assembly With Nut
    G04045335Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  3. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See step 3 in  INSTALLATION  ) 
  4. INSTALL EXHAUST PIPE ASSEMBLY FRONT (See step 4 in  INSTALLATION  ) 
  5. INSTALL OXYGEN SENSOR (See  INSTALLATION  ) 
  6. INSTALL FRONT CENTER FLOOR BRACE (See step 7 in  INSTALLATION  ) 
  7. INSTALL NO. 1 REAR FLOOR PANEL BRACE (See step 8 in  INSTALLATION  ) 
  8. INSTALL NO. 2 CONSOLE BOX DUCT (See step 7 in  INSTALLATION  ) 
  9. INSTALL CONSOLE BOX (See step 42 in  INSTALLATION  ) 
  10. INSTALL CONSOLE BOX REGISTER ASSEMBLY (See step 43 in  INSTALLATION  ) 
  11. INSTALL FRONT ASH RECEPTACLE SUB-ASSEMBLY (See step 44 in  INSTALLATION  ) 
  12. INSTALL CONSOLE PANEL SUB-ASSEMBLY (See step 47 in  INSTALLATION  ) 
  13. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH (See step 48 in  INSTALLATION  ) 
  14. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH (See step 49 in  INSTALLATION  ) 
  15. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 
  16. ADJUST SHIFT LEVER POSITION (See  ADJUSTMENT   ) 
  17. INSPECT SHIFT LEVER POSITION (See  ON-VEHICLE INSPECTION   ) 
  18. CHECK FOR EXHAUST GAS LEAKS (See step 9 in  INSTALLATION  )