LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2004 >> GS 430 >> Repair and Diagnosis >> Engine Performance >> System >> Engine (3UZ-FE) - Diagnostics >> Circuit Inspection >> MIL Circuit Malfunction >> Inspection Procedure

Inspection Procedure

HINT:

Troubleshoot each trouble symptom in accordance with the chart below.

Fig 1: Trouble Symptom Chart
G01488693Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Clear DTC. 
    1. Connect the hand-held tester or the OBD II scan tool to the DLC3.
    2. Turn the ignition switch ON and push the hand-held tester or the OBD II scan tool main switch ON.
    3. Read the DTC (See PRE-CHECK ).
    4. Clear the DTC (See PRE-CHECK ).
    5. Check that MIL does not light up.

    Standard: MIL does not light up 

    1. OK: Repair circuit indicated by output code (See  DIAGNOSTIC TROUBLE CODE CHART  ).  
    2. NG: Go to next step 
  2. Check Harness and connector (Check for short in wire harness). 
    1. Disconnect the E5 ECM connector.
    2. Turn the ignition switch ON.
    3. Check that MIL does not light up.
    Fig 2: Disconnecting E5 ECM Connector
    G01488694Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Standard: MIL does not light up 

    1. OK: Replace ECM (See  ENGINE CONTROL MODULE (ECM)  ).  
    2. NG: Go to next step 

      Check and repair harness and connector between combination meter and ECM. 

  3. Check that MIL lights up. 

    Check that MIL lights up when turning the ignition switch ON.

    Standard: MIL lights up 

    1. OK: System is OK. 
    2. NG: Go to next step 
  4. Inspect combination meter assy (MIL circuit). 

    See the combination meter troubleshooting, go to COMBINATION METER .

    1. NG: Repair or replace bulb or combination meter assembly. 
    2. OK: Go to next step 

      Check and repair harness and connector between combination meter and ECM.