LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2004 >> GS 430 >> Repair and Diagnosis >> Engine Performance >> System >> Engine (3UZ-FE) - Diagnostics >> Circuit Inspection >> DTC P2118: Throttle Actuator Control Motor Current Range/Performance >> Inspection Procedure

Inspection Procedure

HINT:

Read freeze frame data using the hand-held tester or the OBD II scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, as well as other data from the time when a malfunction occurred.

  1. Check ETCS fuse. 

    PREPARATION: 

    Remove the ETCS fuse from the engine room No. 1 R/B.

    CHECK: 

    Check the continuity of the ETCS fuse.

    Fig 1: Identifying ETCS Fuse
    G01488645Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    OK: 

    Continuity 

    1. NG: Check for short in all harness and components connected to ETCS fuse. 
    2. OK: Go to next step 
  2. Check voltage between terminal +BM of ECM connector and body ground. 

    PREPARATION: 

    Remove the engine room ECU cover (See ENGINE CONTROL MODULE (ECM) ).

    CHECK: 

    Measure the voltage between terminal +BM of the ECM connector and body ground.

    Fig 2: Checking Voltage Between Terminal +BM Of ECM Connector & Body Ground
    G01488646Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    OK: 

    Voltage: 9 to 14 V 

    1. OK: Check for intermittent problems (See  PRE-CHECK  ).  
    2. NG: Go to next step 
  3. Check for open and short in harness and connector between battery and ETCS fuse, ETCS fuse and ECM (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ).  
    1. NG: Repair or replace harness or connector. 
    2. OK: Go to next step 

      Check engine room No. 1 R/B.