LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2003 >> SC 430 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Communication System >> Telephone Transceiver ASSY (2003 My) >> Replacement

Telephone Transceiver ASSY (2003 My): Replacement

HINT:

The installation is in the reverse order of the removal. However when there is a special point concerning the installation, it is indicated.

  1. REMOVE SPARE WHEEL COVER ASSY 
  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 
  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH 
  4. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH 
  5. REMOVE TOOL BOX COVER 
  6. REMOVE LUGGAGE HOLD BELT STRIKER ASSY 
  7. REMOVE TONNEAU COVER ASSY 
  8. REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER LOWER 
  9. REMOVE REAR FLOOR FINISH SIDE PLATE RH 
  10. REMOVE REAR FLOOR FINISH SIDE PLATE LH 
  11. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT 
  12. REMOVE LUGGAGE COMPARTMENT TRAY BRACKET FRONT 
    1. Remove the 2 nuts and 3 bolts.
    2. Remove the 2 luggage compartment tray bracket fronts.
    Fig 1: Removing Luggage Compartment Tray Bracket Front Nuts And Bolts
    G01321119Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE TRANSCEIVER & BATTERY ASSY 
    1. Disconnect the connectors and clamps.
    2. Remove the 3 nuts and transceiver & battery assembly.
    Fig 2: Removing 3 Nuts And Transceiver & Battery Assembly
    G01321120Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE PORTABLEPHONE-L BATTERY 
    1. Remove the nut and mobile bracket No.2.
    2. Disconnect the connector, and then remove the portable-phone-L battery.
  15. REMOVE TELEPHONE TRANSCEIVER ASSY 
    1. Disconnect the connectors and clamps.
    2. Remove the 3 screws and telephone transceiver assembly from the mobile bracket No.1.
    NOTE: The telephone transceiver assembly should be replaced together with the mayday ECU assembly.
  16. INSTALL TRANSCEIVER & BATTERY ASSY 
    1. Disconnect the 2 dummy connectors from the wire harness connectors of a new telephone transceiver assembly, and connect those wire harness connectors each other.
    2. Install the transceiver & battery assembly with the 3 nuts.

      Torque: 7.0 N.m (71 kgf.cm, 62 in.lbf) 

      Fig 3: Disconnecting 2 Dummy Connectors From Wire Harness Connectors
      G01321121Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: Make sure that the last 4 digits of serial No. of the mayday ECU assembly correspond to those of the telephone transceiver assembly.
      Fig 4: Identifying Serial No.
      G01321122Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the connectors and clamps.