LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2003 >> LS 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Starting System) >> Removal & Installation >> Starter >> 4.7L

Removal & Installation: Starter: 4.7L

WARNING: This page is about a different car, the 2004 Toyota 4Runner and 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Relieving pressure from fuel system may cause manufacture trouble code DTC P0171 (system too lean) as an output.
  1. Relieve pressure from fuel system. See appropriate BASIC DIAGNOSTIC PROCEDURES article under ENGINE PERFORMANCE.
  2. Drain engine coolant.
  3. Disconnect negative battery terminal clamp from the battery.
  4. Remove the 2 cap nuts and throttle body cover subassembly.
  5. remove air cleaner hose assembly.
  6. Disconnect fuel hose.
  7. Disconnect fuel hose No. 2.
  8. Disconnect fuel vapor feed hose assembly.
  9. Separate engine wire:
    1. Disconnect 3 fuel injector connectors.
    2. Disconnect throttle position sensor connector.
    3. Disconnect water temperature sensor connector.
    4. Remove the 3 bolts and separate engine wire harness.
  10. Disconnect bypass hose No. 7.
  11. Disconnect bypass hose.
  12. Remove the 6 bolts and 4 nuts, intake manifold assembly and 2 gaskets.
  13. Separate the engine wire No. 2. Remove the nut and water bypass pipe subassembly.
  14. Remove the 4 nuts, water bypass joint and 2 gaskets.
  15. Remove starter assembly:
    1. Disconnect the starter connector.
    2. Remove the nut and disconnect the starter cable.
    3. Remove the bolt and disconnect the engine wire protector.
    4. Remove the 2 starter mounting bolts and starter.
  16. Install starter assembly:
    1. Install the starter assembly with the 2 starter mounting bolts.
    2. Connect the engine wire protector with the bolt.
    3. Install the starter cable with the terminal No. 30 nut. Tighten nut to specification. See TORQUE SPECIFICATIONS .
    4. Connect the starter connector.
  17. Install right rear water bypass joint:
    1. Install 2 NEW gaskets to the cylinder head.
    2. Install the 4 nuts holding the water bypass joint to the cylinder heads. In incremental steps, alternately tighten the nuts to specification. See TORQUE SPECIFICATIONS .
  18. Install water bypass pipe subassembly:
    1. Apply soapy water to the "O" ring.
    2. Install a new "O" ring to the water bypass pipe.
    3. Push in the water bypass pipe end into the pipe hole of the water pump.
    4. Install the water bypass pipe with the bolt. Tighten bolt to specification. See TORQUE SPECIFICATIONS .
    5. Install the wire clamp to the bracket of the water bypass pipe.
  19. Install intake manifold assembly:
    1. Instal the 2 new gaskets to cylinder head.
    2. Install the intake manifold assembly with the 6 bolts and 2 nuts. See TORQUE SPECIFICATIONS .
  20. Connect water bypass hose.
  21. Connect water bypass hose No. 7.
  22. Install battery cable clamp to the negative battery terminal. tighten cable clamp bolt to specification. See TORQUE SPECIFICATIONS .
  23. Connect fuel vapor feed hose assembly.
  24. Connect fuel hose No. 2.
  25. Connect fuel hose.
  26. Install air cleaner hose assembly.
  27. Install throttle body cover subassembly.
  28. Refill engine coolant.
  29. Inspect vehicle for engine coolant leaks.
  30. Inspect vehicle for fuel leaks.