Code B1422/22: Compressor Lock Sensor Circuit
- Locate Engine Control Module (ECM) in engine compartment. Leave harness connectors attached. Start engine. Press AUTO button to ON position.
- Backprobe ECM connector terminal E5-10 (White/Blue wire) with positive voltmeter lead and connect negative voltmeter lead to ground. Battery voltage (10-14 volts) should exist.
- If battery voltage exists, no problem is indicated at this time. If battery voltage does not exist, test compressor (A/C magnetic clutch) lock sensor. See COMPRESSOR LOCK SENSOR under TESTING. If sensor is okay, go to next step. Replace sensor as necessary.
- Inspect wiring harness and connectors between A/C ECU, ECM, and compressor lock sensor. Repair harness and connectors as necessary. If wiring harness and connectors are okay, temporarily substitute known-good ECM and/or A/C ECU, and retest system.