Circuit Description
Relay supplies power to each ABS solenoid. After ignition switch is turned on, and system performed initial check, relay turns on if initial check is okay. DTC 11 is set when ABS solenoid relay malfunctions, or battery voltage will not exceed 17 volts within 2.16 seconds. DTC 11 will also set when battery voltage will not drop below 9.5 volts within 2.16 seconds, or after solenoid relay is on, ABS/TRAC ECU does not detect 8 volts or more at A19 connector terminal No. 10 (Red wire) See Figure.
DTC 12 is set when ABS solenoid relay is off before main routine has been performed, and ABS/TRAC ECU does not detect 8 volts or more at A19 connector terminal No. 10 (Red wire) for 2.04 seconds or more. If trouble occurs in ABS solenoid relay circuit, ECU performs a fail safe function, turning off current to ABS solenoid relay and prohibiting ABS and TRAC control. Possible causes are:
- ABS Solenoid Relay
- ABS Solenoid Relay Circuit
- ABS/TRAC ECU