Test 5 (Parking Brake Switch Circuit)
Cruise control ECU applies a reference voltage to parking brake switch to sense whether switch is open or closed. With parking brake released, switch is open. When parking brake is applied, switch closes and cruise control ECU disengages cruise control.
- Start engine. Apply parking brake. BRAKE warning light on instrument cluster should come on. Release parking brake. Light should go out. If light does not operate as specified, repair parking brake warning light circuit.
- If light operates as specified, check parking brake input signal circuit. See INPUT SIGNAL CIRCUITS . If input signal circuit is okay, perform next procedure listed in DIAGNOSIS BY SYMPTOM table.
- If input signal circuit is not okay, remove cruise control ECU, but leave electrical connector(s) attached. Turn ignition on. Measure voltage between ground and following terminal of cruise control ECU connector. See Figure.
- Terminal No. 3
- With parking brake applied, voltage should be less than one volt. With parking brake released, battery voltage should be present. If voltage is as specified, perform next procedure listed in DIAGNOSIS BY SYMPTOM table.
- If voltage is not as specified, check for faulty circuit between cruise control ECU and brake warning light. If circuit is okay, replace cruise control ECU.