Power Rack & Pinion: Reassembly
- Lubricate all parts with power steering fluid. Using Handle (09631-12020
) and Oil Seal Replacer (09631-32010
), install oil seal. Tape exposed portion of oil seal replacer. Insert rack into housing. DO NOT damage seal.
- Coat lip of oil seal with power steering fluid. Wrap end of rack with vinyl tape. Slide seal over end of rack and into rack housing. DO NOT tilt seal. Install spacers. Using Oil Seal Replacer (09631-00200
), drive in cylinder end stopper. Install snap ring.
- Connect Steering Rack Oil Seal Tester (09631-12071
) to pressure tube fittings. Apply 16 in. Hg vacuum to rack assembly. If vacuum does not hold for 30 seconds, check installation of oil seals.
- Install control valve and control valve housing. Install lower bearing and spacer. Apply Three Bond 1344 sealant to 2 or 3 threads of rack housing cap. Install lock nut and rack housing cap. Install rack guide seat, rack guide, and rack guide spring.
- Apply sealant to 2 or 3 threads of spring cap. Tighten spring cap to 18 ft. lbs. (25 N.m). Rotate spring cap 12 degrees counterclockwise. Rotate control valve shaft right and left 2 times. Loosen spring cap until spring is not compressed.
- Attach INCH-lb. torque wrench to control valve shaft. Tighten rack guide spring cap until control valve rotating torque is as specified in RACK PRELOAD .
RACK PRELOAD
| Application |
INCH Lbs. (N.m) |
| LS400 |
8-11 (.9-1.2) |
- Apply sealant to 2 or 3 threads rack guide spring cap lock nut. Tighten lock nut to 41 ft. lbs. (55 N.m). Recheck control valve turning torque, and readjust if necessary. To complete assembly, reverse disassembly procedure.