Clutch Assembly: Installation
- Mount disc and cover on flywheel with clutch alignment mandrel. Tighten bolts evenly and gradually, making several passes until final torque is reached. See TORQUE SPECIFICATIONS at end of article. See Fig 1.
- With a dial indicator, check diaphragm spring tip alignment. If misalignment is greater than .020" (.5 mm), adjust diaphragm spring tips using Alignment Tool (09333-00013
). See Fig 2.
- Apply molybdenum disulphide lithium-based grease to release fork and hub contact points, release fork and push rod contact point, release fork pivot point and clutch disc spline.
- Install release bearing assembly to fork and then install together into transaxle. Install boot. Reverse removal procedure to complete installation.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002