Power Steering Rack: Installation
- Fit PAS rack to vehicle from passengers side.
- Fit dust shield to pinion housing.
- On KV6 models: Fit RH Hydramount. See HYDRAMOUNT -- ENGINE -- RIGHT .
- Ensure pipe unions are clean.
- Fit NEW "O" rings to fluid pipes.
- Fit fluid pipes to PAS rack but do not tighten at this stage.
- Align fluid pipe bracket to PAS rack, fit bolt but do not tighten at this stage.
- With assistance fit PAS rack pinion to steering column, ensuring column coupling is aligned with gear input flag.
- Fit washers and new bolts securing steering rack mounting to bulkhead, but do not tighten at this stage. Ensure large washer is fitted to lower bolt.
- Fit rubber mount and clamp to PAS rack.
- Fit bolts securing clamp to bulkhead but do not tighten at this stage.
- Tighten PAS rack mounting bolts to 45 Nm (33 ft. lbs).
- Tighten PAS rack clamp bolts to 45 Nm (33 ft. lbs).
- Tighten PAS rack fluid feed pipe union to 18 Nm (13 ft. lbs).
- Tighten PAS rack fluid return pipe union to 22 Nm (16 ft. lbs).
- Tighten fluid pipe bracket to 10 Nm (7 ft. lbs).
- Align PAS rack clamp and tighten bolt.
- Align pipes to clamp fit bolt and tighten to 10 Nm (7 ft. lbs).
- Fit pinch bolt to steering column and tighten to 32 Nm (24 ft. lbs).CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
- Ensure tapers in track rod end and steering arm are clean and rubber boot is not damaged.
- Fit ball joints to steering arms, fit new nuts and tighten to 55 Nm (40 ft. lbs).
- On KV6 models: Align coolant rail to cylinder block, fit bolts and tighten to 10 Nm (7 ft. lbs).
- On KV6 models: Position heat shield, fit nuts and tighten to 25 Nm (18 ft. lbs).
- On Td4 manual models: Align IRD hose "P" clip fit bolt and tighten to 25 Nm (18 ft. lbs).
- On Td4 manual models: Align gear-change linkage to bulkhead, fit bolts and tighten to 25 Nm (18 ft. lbs).
- On Td4 manual models: Connect gear change rods to gear change linkage.
- On Td4 auto models: Align IRD hose "P" clip fit bolt and tighten to 25 Nm (18 ft. lbs).
- Fit road wheel(s) and tighten nuts to 115 Nm (85 ft. lbs).
- Remove stands and lower vehicle.
- Bleed PAS system. See POWER ASSISTED STEERING (PAS) SYSTEM - BLEED .
- Check and adjust front wheel alignment. See FRONT WHEEL ALIGNMENT - CHECK & ADJUST .