Master Cylinder
The master cylinder assembly produces hydraulic pressure to operate the brakes when the brake pedal is pressed. The assembly is attached to the front of the brake servo assembly, and comprises a cylinder containing two pistons in tandem. The rear piston produces pressure for the primary circuit and the front piston produces pressure for the secondary circuit.
The brake fluid reservoir is located on top of the master cylinder assembly. The reservoir is internally divided to provide an independent supply of fluid to each brake circuit, and so prevent a single fluid leak from disabling both primary and secondary brake circuits. Should a failure occur in one circuit, the remaining circuit will still operate effectively, although brake pedal travel and vehicle braking distances will increase.
If the fluid level in the reservoir is too low, the brake fluid level switch in the reservoir filler cap breaks a contact to the DSC ECU, which sends a CAN message to illuminate the brake warning lamp in the instrument pack and displays the message 'CHECK BRAKE FLUID' in the instrument pack.
- Brake fluid level switch
- Brake fluid reservoir
- Retaining pin
- Retaining nut
- Plate
- Retaining clip
- Brake servo
- O ring
- Nut
- Master cylinder assembly
- Seals
Hydraulic Circuit
- Fluid reservoir cap with fluid level sensor
- Master cylinder
- Pre charge pump motor
- Brake pressure sensor
- ABS pump motor
- Pre charge pump
- Damper
- Separation valve
- Solenoid valve
- One way check valve
- ABS pump
- Check valve
- Restrictor valve
- Low pressure accumulator
- Damper
- Right Inlet valves
- Left Inlet valves
- Right outlet valves
- Left outlet valves
- Right rear brake
- Left rear brake
- Left front brake
- Right front brake
When the brake pedal is pressed, the front push rod in the brake servo assembly pushes the primary piston along the cylinder bore. This produces pressure in the primary pressure chamber which, in conjunction with the primary spring, overcomes the secondary spring and simultaneously moves the secondary piston along the cylinder bore. The initial movement of the pistons, away from the piston stops, closes the primary and secondary center valves. Further movement of the pistons then pressurizes the fluid in the primary and secondary pressure chambers, and thus the brake circuits. The fluid in the chambers, behind the pistons, is unaffected by movement of the pistons and can flow unrestricted through the feed holes between the chambers and the reservoir. When the brake pedal is released, the primary and secondary springs push the pistons back down the bore of the cylinder. As the pistons contact the piston stops, the primary and secondary center valves open, which allows fluid to circulate unrestricted between the two hydraulic circuits and the reservoir, through the center valves, the chambers behind the pistons and the feed holes.