LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2002 >> Freelander SE >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Removal & Installation >> Power Steering Rack >> Installation

Power Steering Rack: Installation

  1. Fit PAS rack to vehicle from passengers side.
  2. Fit dust shield to pinion housing.
  3. On KV6 models: Fit RH Hydramount. See HYDRAMOUNT -- ENGINE -- RIGHT .
  4. Ensure pipe unions are clean.
  5. Fit NEW "O" rings to fluid pipes.
  6. Fit fluid pipes to PAS rack but do not tighten at this stage.
  7. Align fluid pipe bracket to PAS rack, fit bolt but do not tighten at this stage.
  8. With assistance fit PAS rack pinion to steering column, ensuring column coupling is aligned with gear input flag.
  9. Fit washers and new bolts securing steering rack mounting to bulkhead, but do not tighten at this stage. Ensure large washer is fitted to lower bolt.
  10. Fit rubber mount and clamp to PAS rack.
  11. Fit bolts securing clamp to bulkhead but do not tighten at this stage.
  12. Tighten PAS rack mounting bolts to 45 Nm (33 ft. lbs).
  13. Tighten PAS rack clamp bolts to 45 Nm (33 ft. lbs).
  14. Tighten PAS rack fluid feed pipe union to 18 Nm (13 ft. lbs).
  15. Tighten PAS rack fluid return pipe union to 22 Nm (16 ft. lbs).
  16. Tighten fluid pipe bracket to 10 Nm (7 ft. lbs).
  17. Align PAS rack clamp and tighten bolt.
  18. Align pipes to clamp fit bolt and tighten to 10 Nm (7 ft. lbs).
  19. Fit pinch bolt to steering column and tighten to 32 Nm (24 ft. lbs).
    CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
  20. Ensure tapers in track rod end and steering arm are clean and rubber boot is not damaged.
  21. Fit ball joints to steering arms, fit new nuts and tighten to 55 Nm (40 ft. lbs).
  22. On KV6 models: Align coolant rail to cylinder block, fit bolts and tighten to 10 Nm (7 ft. lbs).
  23. On KV6 models: Position heat shield, fit nuts and tighten to 25 Nm (18 ft. lbs).
  24. On Td4 manual models: Align IRD hose "P" clip fit bolt and tighten to 25 Nm (18 ft. lbs).
  25. On Td4 manual models: Align gear-change linkage to bulkhead, fit bolts and tighten to 25 Nm (18 ft. lbs).
  26. On Td4 manual models: Connect gear change rods to gear change linkage.
  27. On Td4 auto models: Align IRD hose "P" clip fit bolt and tighten to 25 Nm (18 ft. lbs).
  28. Fit road wheel(s) and tighten nuts to 115 Nm (85 ft. lbs).
  29. Remove stands and lower vehicle.
  30. Bleed PAS system. See POWER ASSISTED STEERING (PAS) SYSTEM - BLEED .
  31. Check and adjust front wheel alignment. See FRONT WHEEL ALIGNMENT - CHECK & ADJUST .