Removal & Installation
- Remove the parking release cable after removing the fastener (A).
- Remove the parking release lever (A) after removing the nut.
- Remove the parking switch (A) after removing the bolts.
- Disconnect the parking switch connector (A).
Installation
- Connect the parking switch connector (A).
- Install the parking switch (A) and parking release lever (B).NOTE: Lightly tighten the bolts and nut so that necessary adjustments can be made.
- Align the hole in the parking release lever with the "P" position hole of the parking switch and then insert the SST parking switch guide pin (09480 - D2100).
- Tighten the parking switch mounting bolts (A).
Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)
- Tighten the parking release lever mounting nut (A).
Tightening torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb.ft)
- Remove the SST (09480 - D2100)
- Tighten the fastener (A) after installing the parking release cable.
NOTE:
The existing fastener (A) must be replaced with a new one (do not reuse).