LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Stinger GT-Line, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System - 3.3L) >> Oil Pressure Sensor (OPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Remove the water center pipe.

    (Refer to Engine Mechanical System - "WATER TEMPERATURE CONTROL ASSEMBLY ")

  3. Disconnect the connector (A), and then remove the CVVT oil pressure sensor (B).
G14999910Courtesy of KIA MOTORS AMERICA, INC.