Repair Procedures: Installation
- Install in the reverse order of removal.NOTE:
- If the vehicle's parasitic current is being consumed more than 100 mA, an abnormal signal from the battery sensor may appear. If an abnormal signal from the battery sensor is displayed, measure the parasitic current before proceeding with the battery sensor replacement procedure.
(Refer to Charging System - "INSPECTION ")
- If the parasitic current is normal, replace the Battery Sensor and perform the following procedures.
- Turn the ignition switch ON - OFF and Leave it at least for 4 hours.
- Inspect the SOC of the battery using KDS.
- Turn the ignition switch ON - OFF twice or more and Inspect the SOC of battery.
- For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when the battery is replaced or recharged.
- When replacing the battery, it should be same one (type, capacity and brand) that is originally installed on your vehicle. If a battery of a different type is replaced, the battery sensor may recognize the battery to be abnormal.
- When installing the ground cable on the negative post of battery, tighten the clamp with specified torque. An excessive tightening torque can damage the PCB internal circuit and the battery terminal.
- When recharging the battery, ground the battery negative (-) terminal of the booster battery to the vehicle body.
- If the vehicle's parasitic current is being consumed more than 100 mA, an abnormal signal from the battery sensor may appear. If an abnormal signal from the battery sensor is displayed, measure the parasitic current before proceeding with the battery sensor replacement procedure.