Repair Procedures: Removal
- Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
- Remove the front seat.
(Refer to Body - "FRONT SEAT ASSEMBLY ")
- Disengage the rear seat cushion.
(Refer to Body - "REAR SEAT ASSEMBLY ")
- Separate the front seat belt (A) from the emergency fastening device.NOTE: Anchor seat belt separation method
- Expose the red colored indicator pin (A) by pushing the slot hole using a Ø 1.5mm pointed tool as below illustration.CAUTION: Be careful not to scratch the anchor cover by a pointed tool when pushing the slot hole.
- Put a (-) driver (Ø4mm) into a latch hole ((2)) and turn it clockwise.
- Remove the connector by pulling seat belt ((3)).NOTE: When connecting the anchor connector, securely connect it until "click" sound is heard.
- Expose the red colored indicator pin (A) by pushing the slot hole using a Ø 1.5mm pointed tool as below illustration.
- Remove the center pillar lower trim.
(Refer to Body - "CENTER PILLAR TRIM ")
- Remove the floor carpet assembly.
(Refer to Body - "FLOOR CARPET ")
- Disconnect the EFD connector
and then remove the emergency fastening device
by loosening the mounting bolts.
Tightening torque:
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)