Repair Procedures: Replacement
NOTE:
- When installing the belt, make sure not to damage the retractor.
- Remove the luggage side trim.
(Refer to Trunk Trim - "LUGGAGE SIDE TRIM ")
- Remove the rear pillar trim.
(Refer to Interior Trim - "REAR PILLAR TRIM ")
- Separate the rear seat upper anchor (A) after loosening the mounting bolt.
Tightening torque:
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb.ft)
- After loosening the mounting bolt, remove the rear seat belt retractor (B).
Tightening torque:
39.2 - 53.9 N.m (4.0 - 5.5 Kgf.m, 28.8 - 39.8 lb.ft)
- To install, reverse removal procedure.
Information
- Make sure the connector is plugged in properly.
- Replace any damaged clips (or pin-type retainers).