LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2021 >> Forte EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Brake System) >> Rear Drum Brake >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2024 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid does contact the paint. Wash it off immediately with water.
  • To prevent spills, cover the hose joints with rags or shop towels.
  • Use only a genuine wheel cylinder special bolt.
  1. Apply sealant (C) between the wheel cylinder (B) and backing plate (D), and install the wheel cylinder.
    G14561967Courtesy of KIA MOTORS AMERICA, INC.
  2. Connect the brake tubes (A) to the wheel cylinder.

    Tightening torque: 

    12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb.ft)

  3. Connect the parking brake cable (A) to the brake shoe.
    G14561968Courtesy of KIA MOTORS AMERICA, INC.
  4. Install the brake shoes (C) onto the backing plate. Be careful not to damage the wheel cylinder dust covers.
    G14561969Courtesy of KIA MOTORS AMERICA, INC.
  5. Install the shoe hole down pins (B) and the shoe hole down springs (A).
  6. Clean the threaded portions of adjuster sleeve (A) and push rod female (B). Coat the threads of the adjuster assembly with grease. To shorten the clevises, turn the adjuster bolt (C).
    G14561970Courtesy of KIA MOTORS AMERICA, INC.
  7. Hook the shoe adjuster lever (C), then install it to the brake shoe.
    G14561971Courtesy of KIA MOTORS AMERICA, INC.
  8. Install the adjuster assembly (B) and upper return spring (A) as right direction. Be careful not to damage the wheel cylinder dust covers.
    G14561972Courtesy of KIA MOTORS AMERICA, INC.
  9. Install the lower return spring (B).
    G14561973Courtesy of KIA MOTORS AMERICA, INC.
  10. Apply brake cylinder grease or equivalent rubber grease to the sliding surfaces shown. Don't get grease on the brake linings.
    G14561974Courtesy of KIA MOTORS AMERICA, INC.
  11. Apply brake cylinder grease or equivalent rubber grease to the brake shoe ends and opposite edges of the shoes shown. Don't get grease on the brake linings.
    G14561975Courtesy of KIA MOTORS AMERICA, INC.
  12. Install the rear brake drum (A).

    Tightening torque: 

    4.9 - 5.9 N.m (0.5 - 0.6 kgf.m, 3.6 - 4.3 lb.ft)

    G14561976Courtesy of KIA MOTORS AMERICA, INC.
  13. If the wheel cylinder has been removed, bleed the brake system.
  14. Depress the brake pedal several times to set the self-adjusting brake.
  15. Adjust the parking brake.