LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> K900 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Hydraulic System >> Line Pressure Control Solenoid Valve (LINE_VFS) >> Repair Procedures >> Removal

Repair Procedures: Removal

NOTE:
  • Maintain clean condition so that foreign substance does not get into the automatic transmission.
  • Use a coated apron, latex gloves, and stainless tray to prevent foreign substance from getting into the transmission.
  1. Remove the under cover.

    G 3.3 T-GDI LAMBDA II (Refer to Engine Mechanical System - " ENGINE ROOM UNDER COVER  ") 

  2. Remove the ATF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.

    Tightening torque: 

    22.6 - 24.5 N.m (2.3 - 2.5 kgf.m, 16.6 - 18.1 lb.ft)

    G13143845Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • ATF can be reused. Collect it in a clean beaker.
    • The existing ATF drain plug O-ring must be replaced with a new one. (Do not reuse it.)
    G13143846Courtesy of KIA MOTORS AMERICA, INC.
  3. Disconnect the main connector (A).
    G13143847Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the valve body cover.
    1. Loosen the all valve body mounting bolts except for the bolts (A) in the corner.

      Tightening torque: 

      13.7 - 15.7 N.m (1.4 - 1.6 kgf.m, 10.1 - 11.6 lb.ft)

      G13143848Courtesy of KIA MOTORS AMERICA, INC.
    2. Loosen the two bolts (A) in the corner after supporting the valve body cover on a jack and then remove the valve body cover by lowering the jack slowly.
    G13143849Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Be careful when removing the valve body cover because the remaining ATF remains in the valve body cover.
    G13143850Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the valve body assembly (A) after loosening the bolts.

    Tightening torque: 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

    G13143851Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the E-module (A) after loosening the bolts.

    Tightening torque: 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

    G13143852Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: When installing, after mounting the E-module, lightly tap the connector part (A) to insert the connector certainly and then tighten the bolts.
    G13143853Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the solenoid valve support bracket (A).

    Tightening torque: 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

    G13143854Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the line pressure control solenoid valve (A).
G13143855Courtesy of KIA MOTORS AMERICA, INC.