LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Stinger GTS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - 2.0L) >> Barometric Pressure Sensor (BPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Disconnect the boost pressure sensor connector (A).
  3. Remove the mounting bolts (B), and then remove the sensor from the intercooler outlet pipe.

    Boost pressure sensor mounting bolt: 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

    G12792278Courtesy of KIA MOTORS AMERICA, INC.