LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Stinger GTS, AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System - 3.3L >> Fuel Tank >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - " RELEASE RESIDUAL PRESSURE IN FUEL LINE  ") 

  2. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  3. Remove the rear seat cushion.

    (Refer to Body - " REAR SEAT ASSEMBLY  ") 

  4. Remove the fuel pump service cover (A) after loosening the mounting screws.
    G12803674Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the fuel feed quick-connector (A).
  6. Disconnect the fuel pressure sensor connector (B).
  7. Disconnect the fuel pump connector (C).
    G12803675Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the sub fuel sender service cover (A) after loosening the mounting screws.
    G12803676Courtesy of KIA MOTORS AMERICA, INC.
  9. Disconnect the sub fuel sender connector (A).
    G12803677Courtesy of KIA MOTORS AMERICA, INC.
  10. Lift the vehicle.
  11. Remove the center muffler assembly.

    (Refer to Engine Mechanical System - " MUFFLER  ") 

  12. Remove the propeller shaft assembly.

    (Refer to Driveshaft and Axle - " PROPELLER SHAFT  ") 

  13. Disconnect the fuel filler hose (A).
    G12803678Courtesy of KIA MOTORS AMERICA, INC.
  14. Disconnect the ventilation (A).
    G12803679Courtesy of KIA MOTORS AMERICA, INC.
  15. Support the fuel tank with jack (A).
  16. Remove the fuel tank installation nut (B) and then loosen the fuel tank.
    G12803680Courtesy of KIA MOTORS AMERICA, INC.
  17. Remove the fuel tank (A).
    G12803681Courtesy of KIA MOTORS AMERICA, INC.