Cooling Fan Control Module
WARNING: This page is about a different variant/trim than selected.
- Remove the LH front wheel.
(Refer to Suspension System - "WHEEL ")
- Remove the LH front wheel guard.
(Refer to Body - "FRONT WHEEL GUARD ")
- Disconnect the wire harness connector (A) and fan motor extension connector (B).
- Remove the cooling fan control module (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
- Install in the reverse order of removal.