Signal Circuit Inspection
- Ignition "OFF"
- Disconnect battery (-) cable.
- Refer to ESC CONTROL MODULE and applicable service information and disconnect brake lamp switch and HECU connector.
- Measure the resistance between Pin No. 4 (Signal) terminal of brake lamp switch harness connector and Pin No. 30 (Signal) terminal of HECU harness connector.
Specification: Approx. below 1 Ω
- Is the measured value within specification?
YES
- Go to "Component Inspection " procedure.
NO
- Repair open or short in ground circuit and then go to "Verification of Vehicle Repair " procedure.