Circuit Inspection
■ Clutch switch inspection
- Ignition "OFF"
- Refer to REMOVAL and disconnect clutch switch connector.
- Ignition "ON"
- Measure the voltage between Pin No. 2 (signal) terminal of clutch switch harness connector and chassis ground.
Specification: B+
- Ignition "OFF"
- Disconnect battery (-) cable.
- Refer to REMOVAL And ESC CONTROL MODULE disconnect clutch switch & HECU connector.
- Measure the resistance between Pin No. 2 (signal) terminal of clutch switch harness connector and Pin No. 23 (signal) terminal of HECU harness connector.
Specification: Approx. below 1Ω
- Ignition "OFF"
- Disconnect battery (-) cable.
- Refer to REMOVAL and disconnect clutch switch connector.
- Measure the resistance between Pin No. 1 (ground) terminal of clutch switch harness connector and chassis ground.
Specification: Approx. below 1Ω
- Is the measured value within specification?
YES
- Go to "Component Inspection " procedure.
NO
- Repair open or short in circuit and then go to "Verification of Vehicle Repair " procedure.