LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Forte5 EX >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System Diagnosis >> DTC U0001: High Speed CAN Communication Bus off >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF".
  3. Select "Current Data  " mode.
  4. Monitor the "CAN Communication Service Data (Engine RPM, Vehicle Speed, Throttle Position Sensor Angle, Accelerator Pedal Position Sensor)" parameters on the GDS.
    Fig 1: Screen Display - Current Data (Low-RPM)
    G11799658Courtesy of KIA MOTORS AMERICA, INC.
    Fig 2: Screen Display - Current Data (High-RPM)
    G11799659Courtesy of KIA MOTORS AMERICA, INC.
  5. Is measured current data within specification?

    YES 

    • Fault is intermittent caused by poor contact between PCM/TCM and Sensor, and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "VERIFICATION VEHICLE REPAIR " procedure.

    NO