Ground Circuit Inspection
■ Open Or Short Check
- IG "OFF".
- Disconnect Brake Lamp Relay (Stop Signal Electronic Module).
- IG "ON" & ENG "OFF".
- Measure voltage between ground terminal of brake lamp relay (Stop Signal Electronic Module) harness connector and chassis ground.
Specification: Approx. 0V
- IG "OFF".
- Disconnect Brake Lamp Relay (Stop Signal Electronic Module)
- Measure resistance between ground terminal of brake lamp relay (Stop Signal Electronic Module) harness connector and chassis ground.
Specification: Approx. below 1Ω
- Is the measured value within specifications?
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check for open or blown fuse referring to "Circuit Diagram".
- Repair open or short in ground circuit and then, go to "Verification Of Vehicle Repair " procedure.