LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Forte EX >> Repair and Diagnosis >> Brakes >> Traction Control >> Electric Stability Program Diagnosis >> DTC C1205: Wheel Speed Sensor Front-RH Invalid/No Signal >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

Item Detecting Condition Possible cause
DTC Strategy
  • Signal monitoring
  1. Improper installation of wheel speed sensor
  2. Abnormal Rotor and wheel bearing
  3. Faulty Wheel speed sensor (FR)
Case 1-1 (WSS initial monitoring) Monitoring Period
  • After initial start up, vehicle speed reaches 12kph (7.4mph), remonitors at speed of 12 kph (7.4mph) once vehicle is stopped
Threshold Value
  • If any one wheel speed is under 2.75kph (1.7mph) and the vehicle speed is above 12 kph (7.4mph) after initial start up
Case 1-2 (WSS initial monitoring) Monitoring Period
  • Continuous (except the monitoring period of case 1)
Threshold Value
  • Even though wheel speed is normal in case 1-1 (vehicle speed of 12kph), signal fault flag is set, in case minimum speed of any one wheel is less than 2.75kph (1.7mph) during acceleration or deceleration from 12kph (7.4mph) and if minimum speed of wheel is re-detected on same wheel during signal fault flag set condition + 18kph (11.2mph).
    • If wheel speed sensor failure is detected during no control, it stops control immediately
Case3 (WSS differences monitoring) Monitoring Period
  • Continuously on driving
Threshold Value
  • If the following failure is detected caused by difference of wheel speed caused by air gap or missing teeth detection
  1. Vehicle speed is over 20kph (12.4mph) & no fault in ABS/ESP ECU
    1. Monitors difference of free rolling speed of wheel between fastest wheel and each wheel
    2. When maximum wheel speed difference is over 8%
    • If fault is detected for one wheel: Maximum fault detection time: 20s.
    • if fault is detected for two wheels: Maximum fault detection time: 40s.
  2. Monioring maximum wheel speed difference
    1. FL/RL, FR/RR: 6~12kph (3.7~7.4mph)

      FL/FR: 10~16kph (6.2~12.4mph)

      • Fault detection time: Maximum 20s
    2. FL/RL, FR/RR: >12kph (7.4mph)

      FL/FR: > 16kph (12.4mph)

      • Fault detection time: Maximum 10s
  3. Fault detection time is maximum 80s when spin occurs on front wheels
    • If wheel speed sensor failure is detected during no control, it stops control immediately
Fail Safe
  • One or two wheel speed sensor fault
    • Only the ABS/ESP (ESC) functions are inhibited
    • The ABS/ESP (ESC) warning lamps are activated and the EBD warning lamp is not activated
  • More than 2 wheel speed sensor fault
    • The ABS/EBD/ESP (ESC) functions are inhibited
    • The ABS/EBD/ESP (ESC) warning lamps are activated