LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2015 >> Cadenza Premium >> Repair and Diagnosis >> Steering >> Steering Column >> Electric Power Steering >> MDPS Ecu >> Repair Procedures >> Replacement

Repair Procedures: Replacement

NOTE: If a DTC occurs in the ECU, check the connectors and wiring. If no problem is found, replace the ECU.

Before replacing the MDPS ECU, use the diagnostic device to read the settings of the old ECU.

  1. Perform the "ECU data backup" by GDS following in the order below.
    1. Connect self - diagnosis connector (16pins) located in the lower of driver side crash pad to self - diagnosis device.
    2. Turn the self - diagnosis device after key is ON.
    3. After Selecting the "vehicle model" and "EPS system" on GDS vehicle selection screen.
    4. Select the "Part exchange (Power steering ECU)"
      Fig 1: Vehicle S/W Management Screen
      G00570630Courtesy of KIA MOTORS AMERICA, INC.
    5. Follow the instructions shown on the screen.
      Fig 2: Part Exchange (Power Steering ECU) Display Screen (1 of 2)
      G00570631Courtesy of KIA MOTORS AMERICA, INC.
      Fig 3: Part Exchange (Power Steering ECU) Display Screen (2 of 2)
      G00570632Courtesy of KIA MOTORS AMERICA, INC.
    6. Insert the VIN number and then select the "Read" in order to the ECU information save.
      Fig 4: VIN Screen in Part Exchange Display (1 of 2)
      G00570633Courtesy of KIA MOTORS AMERICA, INC.
      Fig 5: VIN Screen in Part Exchange Display (2 of 2)
      G00570634Courtesy of KIA MOTORS AMERICA, INC.
      NOTE: If a DTC occurs in the ECU, check the connectors and wiring. If no problem is found, replace the ECU.
  2. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
  3. Remove the crash pad lower panel.

    (Refer to CRASH PAD )

  4. Loosen the screw and then remove the shower tilt (A).
    Fig 6: Identifying Shower Tilt
    G00570635Courtesy of KIA MOTORS AMERICA, INC.
  5. After loosening the mounting screws, then remove the steering column shroud lower panel (A).
    Fig 7: Identifying Steering Column Shroud Lower Panel
    G00570636Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the MDPS ECU connector (A).
    Fig 8: Identifying MDPS ECU Connector
    G00570637Courtesy of KIA MOTORS AMERICA, INC.
    Fig 9: Disconnecting MDPS ECU Connector
    G00570638Courtesy of KIA MOTORS AMERICA, INC.
  7. Disconnect all connectors connected the steering column & EPS unit assembly.
  8. Remove the steering column & EPS unit assembly by loosening the mounting bolt (A) and nuts (B).

    Tightening torque :

    Nut :12.7 - 17.7 N.m (1.3 - 1.8 kgf.m, 9.4 - 13.0 lb.ft)

    Bolt :44.1 - 49.0 N.m (4.5 - 5.0 kgf.m, 32.5 - 36.2 lb.ft)

    Fig 10: Identifying Steering Column & EPS Unit Assembly Nuts
    G00570639Courtesy of KIA MOTORS AMERICA, INC.
    Fig 11: Identifying Steering Column & EPS Unit Assembly Bolts
    G00570640Courtesy of KIA MOTORS AMERICA, INC.
  9. Disconnect the MDPS ECU connector (A).
    Fig 12: Identifying MDPS ECU Connector
    G00570641Courtesy of FORD MOTOR CO.
  10. Loosen the bolts (A) and then remove the MDPS ECU (B).
    Fig 13: Identifying MDPS ECU and Bolts
    G00570642Courtesy of KIA MOTORS AMERICA, INC.
  11. Loosen the MDPS ECU bracket bolts (A) and then remove the MDPS ECU bracket.
    Fig 14: Identifying MDPS ECU bracket Bolts
    G00570643Courtesy of KIA MOTORS AMERICA, INC.
  12. Install in the reverse order of removal.
  13. Perform the "ECU data restore" by GDS following in the order below.
    1. Connect self - diagnosis connector (16pins) located in the lower of driver side crash pad to self - diagnosis device.
    2. Turn the self - diagnosis device after key is ON.
    3. After Selecting the "vehicle model" and "EPS system" on GDS vehicle selection screen.
    4. Select the "Part exchange (Power steering ECU)"
      Fig 15: Identifying Part exchange (Power steering ECU) Selection
      G00570644Courtesy of KIA MOTORS AMERICA, INC.
    5. Follow the instructions shown on the screen.
      Fig 16: Identifying Power Steering ECU On Screen Instructions (1 of 2)
      G00570645Courtesy of KIA MOTORS AMERICA, INC.
      Fig 17: Identifying Power Steering ECU On Screen Instructions (1 of 2)
      G00570646Courtesy of KIA MOTORS AMERICA, INC.
    6. Insert the VIN number and then select the "Write" in order to the ECU information save.
      Fig 18: Inserting VIN Number Screen
      G00570647Courtesy of KIA MOTORS AMERICA, INC.