LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2015 >> Cadenza Premium >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Block >> Cylinder Block >> Repair Procedures >> Reassembly

Repair Procedures: Reassembly

  1. Install the oil jets (A).

    Tightening torque: 

    27.5 ~ 31.3 N.m (2.8 ~ 3.2kgf.m, 20.2 ~ 23.1lb-ft)

    Fig 1: Identifying Oil Jets
    G09750938Courtesy of KIA MOTORS AMERICA, INC.
  2. Install the crankshaft.

    (Refer to "CRANKSHAFT ")

  3. Install the crankshaft main bearing cap and check oil clearance.

    (Refer to "CRANKSHAFT ")

  4. Check the crankshaft end play.

    (Refer to "CRANKSHAFT ")

  5. Install the piston and connecting rod assemblies.

    (Refer to "PISTON AND CONNECTING ROD ")

  6. Check the connecting rod end play.

    (Refer to "PISTON AND CONNECTING ROD ")

  7. Install the oil drain cover (A) with a new gasket (B).

    Tightening torque: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 2: Identifying Oil Drain Cover With Gasket
    G09750939Courtesy of KIA MOTORS AMERICA, INC.
  8. Install the baffle plate.

    Install and uniformly tighten the baffle plate bolts, in several passes, in the sequence shown.

    Tightening torque: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 3: Baffle Plate Bolts Tightening
    G09750940Courtesy of KIA MOTORS AMERICA, INC.
  9. Install the upper oil pan.

    (Refer to "OIL PAN ")

  10. Install the knock sensor (A).

    Tightening torque: 

    15.7 ~ 23.5 N.m (1.6 ~ 2.4 kgf.m, 11.6 ~ 17.3 lb-ft)

    Fig 4: Identifying Knock Sensor
    G09750941Courtesy of KIA MOTORS AMERICA, INC.
  11. Install the water jacket separator.

    (Refer to "WATER JACKET SEPARATOR ")

  12. Remove the oil cover (A) and gasket (B).

    Tightening torque: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 5: Identifying Oil Cover And Gasket
    G09750942Courtesy of KIA MOTORS AMERICA, INC.
  13. Assemble the other parts in the reverse order of disassembly.

    Information 

    In case the cylinder block is replaced with a new one, select the proper crankshaft main bearing and the piston according to the crankshaft journal bore mark and the cylinder bore mark on the cylinder block.