LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2014 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System - 1.6L >> High Pressure Fuel Pump >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don't do any repair work right after engine stops.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE ").
    WARNING: When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur.
    Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the high pressure fuel pump form
  4. Disconnect the fuel pressure control valve connector (A).
    Fig 1: Identifying Fuel Pressure Control Valve Connector
    G09773120Courtesy of KIA MOTORS AMERICA, INC.
  5. Open the low pressure fuel tube clip (A).
    Fig 2: Identifying Low Pressure Fuel Tube Clip
    G09773121Courtesy of KIA MOTORS AMERICA, INC.
  6. Release the low pressure fuel quick-connector (A) using the clip remover (B).
    Fig 3: Removing Low Pressure Fuel Quick-Connector Using Clip Remover
    G09773122Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: When removing the low pressure fuel quick-connector, use a clip remover as shown in the image below.
    Fig 4: Identifying Low Pressure Fuel Quick-Connector Clip Remover
    G09773123Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the high pressure fuel pipe.

    (Refer to "FUEL LINE - HIGH PRESSURE FUEL LINE ")

  8. Remove the installation bolts (A), and then remove the high pressure fuel pump from the cylinder head assembly.
    NOTE: Unscrew in turn the two bolts in small step (0.5 turns). In case of fully unscrewing one of the two bolts with the other bolt installed, the housing surface of the cylinder head may be broken because of tension of the pump spring.
    Fig 5: Identifying High Pressure Fuel Pump Installation Bolt
    G09773124Courtesy of KIA MOTORS AMERICA, INC.