LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Exterior >> Front Door >> Repair Procedures >> Replacements >> Door Module Assembly Replacement

Door Module Assembly Replacement

  1. Remove the following parts.
    1. Door trim
    2. Door screen
    3. Window glass
    4. Outside handle
  2. Disconnect the outside handle connector (A).
    Fig 1: Identifying Outside Handle Connector
    G08328683Courtesy of KIA MOTORS AMERICA, INC.
  3. Loosen the mounting bolt (A).

    Tightening torque: 

    0.7~0.5N.m (0.07~0.1kgf.m, 1.0~0.7 lb-ft)

    Fig 2: Identifying Outside Handle Mounting Bolt
    G08328684Courtesy of KIA MOTORS AMERICA, INC.
  4. Loosen the rear channel mounting nuts.
  5. After disconnecting the glass molding, remove the rear channel (A).
    Fig 3: Identifying Door Module Rear Channel
    G08328685Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the rod (A).
    Fig 4: Identifying Door Module Rod
    G08328686Courtesy of KIA MOTORS AMERICA, INC.
  7. Disconnect the clip (A).
    Fig 5: Identifying Door Module Clip
    G08328687Courtesy of KIA MOTORS AMERICA, INC.
  8. Loosen the door module mounting bolts, remove the door module (A).
  9. Disconnect the connector.
  10. Disconnect the door module wiring harness, remove the module assembly.

    Tightening torque: 

    7.8~11.8N.m (0.8~1.2kgf.m, 5.8~8.7 lb-ft)

    Fig 6: Identifying Door Module
    G08328688Courtesy of KIA MOTORS AMERICA, INC.
  11. Installation is the reverse of removal.
    NOTE:
    • The area of whole parts should be applied with sufficient grease.
    • Make sure the connector are connected properly and each rod is connected securely.
    • Make sure door lock operates and door open/close properly.