LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2012 >> Rio EX, 4D Hatchback >> Repair and Diagnosis >> Body & Frame >> Windows >> Interior >> Crash Pad >> Repair procedures >> Replacement >> Cowl Cross Bar Replacement

Cowl Cross Bar Replacement

CAUTION:
  • A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Take care not to bend or scratch the trim and panels.
  • Put on gloves to protect your hands.
  1. Remove the following items:
    1. Front seat

      (Refer to the "FRONT SEAT ")

    2. Front pillar trim

      (Refer to the BD group - "INTERIOR TRIM ")

    3. Floor console assembly

      (Refer to the BD group - "CONSOLE ")

    4. Front door scuff trim

      (Refer to the BD group - "INTERIOR TRIM ")

    5. Cowl side trim

      (Refer to the BD group - "INTERIOR TRIM ")

    6. Cowl top cover

      (Refer to the "COWL TOP COVER ")

    7. Main crash pad assembly
  2. Disconnect the blower unit connectors.

    (Refer to the "AIR CONDITIONING SYSTEM , HEATER , BLOWER ")

  3. Disconnect the multi box connectors (A).

    [Driver's] 

    Fig 1: Identifying Multi Box Connector (Driver)
    G08322571Courtesy of KIA MOTORS AMERICA, INC.

    [Passenger's] 

    Fig 2: Identifying Multi Box Connector (Passenger)
    G08322572Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the passenger compartment junction box connectors (A).
    Fig 3: Identifying Passenger Compartment Junction Box Connectors
    G08322573Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the airbag control module (SRSCM) connectors (A).
    Fig 4: Identifying Airbag Control Module (SRSCM) Connectors
    G08322574Courtesy of KIA MOTORS AMERICA, INC.
  6. After loosening the mounting bolts and nuts, then remove the cowl cross bar assembly (A).
    Fig 5: Identifying Cowl Cross Bar Assembly, Mounting Bolts And Nuts
    G08322575Courtesy of KIA MOTORS AMERICA, INC.
  7. Installation is the reverse of removal.
    NOTE:
    • Make sure the connectors are connected in properly.
    • Replace any damaged clips.