LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2011 >> Soul Base >> Repair and Diagnosis >> Engine Performance >> Ignition System >> General Information (Engine Electrical System) - 1.6L >> General Information >> The Micro 570 Analyzer >> Starter Test Procedure

Starter Test Procedure

  1. After the battery test, press ENTER immediately for the starter test.
    Fig 1: Micro 570 Analyzer Screen Display - Press Enter For Starter Test
    G06526027Courtesy of KIA MOTORS AMERICA, INC.
  2. After pressing ENTER key, start the engine.
    Fig 2: Micro 570 Analyzer Screen Display - Start Engine
    G06526028Courtesy of KIA MOTORS AMERICA, INC.
  3. Cranking voltage and starter test results will be displayed on the screen.

    Take a relevant action according to the test results by referring to the starter test results as given below.

    Fig 3: Micro 570 Analyzer Screen Display - Cranking Voltage Normal
    G06526029Courtesy of KIA MOTORS AMERICA, INC.
  4. To continue charging system test, press ENTER.

    Starter Test Results 

    STARTER TEST RESULTS CHART

    Result On Printer Remedy
    Cranking voltage normal System shows a normal starter draw
    Cranking voltage low Cranking voltage is lower than normal level
    • Check starter
    Charge battery The state of battery charge is too low to test
    • Charge the battery and retest
    Replace battery
    • Replace battery
    • If the vehicle is not started though the battery condition of "Good and fully charged" is displayed.
    • Check wiring for open circuit, battery cable connection, starter and repair or replace as necessary.
    • If the engine does crank, check fuel system.
    NOTE: When testing the vehicle with old diesel engines, the test result will not be favorable if the glow plug is not heated. Conduct the test after warming up the engine for 5 minutes.