LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2011 >> Soul Base >> Repair and Diagnosis >> Electrical >> Starter >> Starting System - 1.6L >> Repair Procedures >> Troubleshooting >> Stater Solenoid Test

Stater Solenoid Test

  1. Disconnect the field coil wire from the M-terminal of solenoid switch.
  2. Connect the battery (+) line to the S-terminal and (-) line to the M-terminal and the stater body.
    CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent the coil from burning.
    Fig 1: Connecting Battery Voltage To S-Terminal & M-Terminal
    G06526074Courtesy of KIA MOTORS AMERICA, INC.
  3. Connect the field coil wire to the M-terminal.
  4. If the pinion moves out, the pull-in coil of solenoid is working properly.

    If the pinion does not move, replace the magnetic switch.

  5. Disconnect the (-) line from the M-terminal.
  6. If the pinion doesn't have moved, the hold-in coil of the solenoid is working properly.
    CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent the coil from burning.
    Fig 2: Disconnecting (-) Line From M-Terminal
    G06526075Courtesy of KIA MOTORS AMERICA, INC.
  7. If the pinion goes back in its original position when you disconnecting the (-) line from the body, the system must be in good condition.
    CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent the coil from burning.
    Fig 3: Disconnecting (-) Line From Body
    G06526076Courtesy of KIA MOTORS AMERICA, INC.