LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Module >> Passenger Airbag (PAB) Module >> Installation

Passenger Airbag (PAB) Module: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
  3. Place a Passenger Airbag (PAB) on the crash pad and tighten the Passenger Airbag (PAB) mounting nuts.

    Tightening torque 

    :0.25 ~ 0.58 kgf.m (2.45 ~ 3.93 N.m, 1.8 ~ 2.75 lb.ft)

  4. Install the heater duct to the crash pad.
  5. Install the crash pad. (Refer to INTERIOR ).
  6. Tighten the PAB mounting bolt.

    Tightening torque

    :1.8 ~ 2.7 kgf.m (17.2 ~ 26.5 N.m, 13.0 ~ 19.5 lb.ft)

  7. Connect the Passenger Airbag (PAB) harness connector to the SRS main harness connector.
  8. Reinstall the glove box. (Refer to INTERIOR ).
  9. Reconnect the battery negative cable.
  10. After installing the Passenger Airbag (PAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.