LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Module >> Curtain Airbag (CAB) Module >> Installation

Curtain Airbag (CAB) Module: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Install a Curtain Airbag (CAB) on the mounting bracket.
  4. Tighten the CAB mounting bolts and nuts.

    Tightening torque

    :0.7 ~ 0.9 kgf.m (7.0 ~ 9.0 Nm, 5.2 ~ 6.6 lb.ft)

    Fig 1: Identifying Curtain Airbag Mounting Bolts & Nuts
    G06386748Courtesy of KIA MOTORS AMERICA, INC.
    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  5. Connect the CAB connector.
  6. Install the following parts. (Refer to INTERIOR ).
    1. Roof trim, Rear pillar trim
    2. Luggage side trim, Rear seat
  7. Reconnect the battery negative cable.
  8. After installing the Curtain Airbag (CAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.