LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Cooling System - 2.7L) >> Repair procedures >> Installation >> Water Temperature Control Assembly

Water Temperature Control Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install the water pipe (A).

    Tightening torque: 

    16.7 ~ 19.6 N.m (1.7 ~ 2.0 kgf.m, 12.3 ~ 14.5 lb-ft)

    Fig 1: Identifying Water Pipe
    G06486388Courtesy of KIA MOTORS AMERICA, INC.
  2. Install the water temperature control assembly (A) with a new gasket (B).

    Tightening torque: 

    29.4 ~ 41.2 N.m (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 lb-ft

    Fig 2: Identifying Water Temperature Control Assembly With Gasket
    G06486389Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Use new O-rings and wet them with water or coolant when reassembling.
  3. Install the wiring protector.
  4. Connect the heater hose and ECT hose.
  5. Connect the ECT sensor connector.
  6. Connect the radiator upper and the lower hose (A).
    Fig 3: Identifying Radiator Upper And Lower Hose
    G06486390Courtesy of KIA MOTORS AMERICA, INC.
  7. Install the air cleaner assembly.
  8. Fill with engine coolant.
  9. Start engine and check for leaks.
  10. Recheck engine coolant level.