LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) - 2.4L >> DTC P0300: Random/Multiple Cylinder Misfire Detected >> Inspection Repair >> System Inspection >> Fuel System Inspection

Fuel System Inspection

  1. Fuel Line Pressure Inspection
    1. Check the fuel for excessive water, alcohol, or other contaminants. Replace contaminated fuel as necessary.
    2. Install a fuel pressure gage
    3. Inspect fuel pressure with normal idle status

      Specification:  338~348kPa (3.45~3.55kg/PCM2 )

    4. Is fuel pressure within the specified value?

      YES 

      • Go to next step.

      NO 

      • Inspect the suspected area. Refer to table as follows. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
        FUEL PRESSURE CONDITION CHART

        Condition Possible Cause Suspected Area
        Fuel Pressure too low Clogged fuel filter Fuel filter
        Fuel leak on the fuel-pressure regulator that is assembled on fuel pump Fuel Pump (Fuel Pressure Regulator)
        Fuel Pressure too High Sticking fuel pressure regulator Fuel Pump (Fuel Pressure Regulator)
  2. Fuel Pressure Hold Inspection
    1. Stop the engine and check for a change in the fuel pressure gauge reading.

      Specification:  After engine stops, the gauge reading should hold for minimum 5 minutes

    2. Is fuel pressure within the specified value?

      YES 

      NO 

      • Inspect the suspected area. Refer to table as follows. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
        FUEL PRESSURE INSPECTION CHART

        Condition Possible Cause Suspected Area
        Fuel pressure drops slowly Injector leak Injector
        Fuel pressure drops immediately tuck open in check valve of the fuel pump Fuel pump