LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) - 2.4L >> DTC P0136: O2 Sensor Circuit (Bank 1/Sensor 2) >> Inspection Repair >> W/Harness Inspection >> Ground Circuit Inspection

Ground Circuit Inspection

  1. Ignition "OFF"
  2. Disconnect HO2S connectors
  3. Measure resistance between ground terminal of HO2S (B1S2) harness connector and chassis ground

    Specification:  Approx. 0Ω

    Fig 1: Measuring Resistance Between Ground Terminal Of HO2S (B1S2) Harness Connector & Chassis Ground
    G06487816Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within the specification?

    YES 

    NO 

    • Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: The HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.