LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) - 2.4L >> DTC P0113: Intake Air Temperature Sensor 1 Circuit High Input >> Inspection Repair >> Component Inspection

Component Inspection

  1. Ignition "OFF"
  2. Disconnect IATS connector3) Measure the resistance between signal terminal and
  3. Measure the resistance between signal terminal and ground terminal of the sensor connector (Component side).

    Specification 

    TEMPERATURE AND RESISTANCE CHART

    Temp. (°C) Temp. (°F) Resistance (kΩ) Temp. (°C) Temp. (°F) Resistance (kΩ)
    -10 14 8.5~9.7 20 68 2.3~2.5
    0 32 5.4~6.1 30 86 1.6~1.7
    10 50 3.5~3.9 80 176 Approx. 0.3
    Fig 1: Measuring Resistance Between Signal Terminal & Ground Terminal Of Sensor Connector
    G06487748Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within the specification?

    YES 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks, or poor terminal-to-wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Check IATS for contamination, deterioration, or damage. Substitute with a known-good IATS and check for proper operation. If the problem is corrected, replace IATS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.