LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rio Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0335 Crankshaft Position Sensor A Circuit >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check Open in signal circuit.
    1. Key "OFF".
    2. Disconnect CKPS connector.
    3. Key "ON".
    4. Measure the voltage between terminal 1 of CKPS harness connector and chassis ground. Then, measure the voltage between terminal 2 of CKPS harness connector and chassis ground.

      Specification: Approx 2.5V

      Fig 1: Measuring Voltage Between Terminal 1 Of CKPS Harness Connector And Chassis Ground
      G06130504Courtesy of KIA MOTORS AMERICA, INC.
    5. Is the measured voltage within specification?

      YES 

      • Go to step  3.

      NO 

      • Go to step  2.
  2. Check Short to ground in signal circuit.
    1. Key "OFF".
    2. Disconnect CKPS connector and ECM/PCM connector.
    3. Measure the resistance between terminal 1 of CKPS harness connector and chassis ground. Then, measure the resistance between terminal 2 of CKPS harness connector and chassis ground.

      Specification: Infinite

      Fig 2: Measuring Resistance Between Terminal 1 Of CKPS Harness Connector And Chassis Ground
      G06130505Courtesy of KIA MOTORS AMERICA, INC.
    4. Is the measured resistance within specifications?

      YES 

      NO 

  3. Check Short in signal circuit.
    1. Key "OFF".
    2. Disconnect CKPS connector and ECM/PCM connector.
    3. Measure the resistance between terminals 1 and 2 of CKPS harness connector.

      Specification: Infinite

      Fig 3: Measuring Resistance Between Terminals 1 And 2 Of CKPS Harness Connector
      G06130506Courtesy of KIA MOTORS AMERICA, INC.
    4. Is the measured resistance within specifications?

      YES 

      NO