LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rio Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0133 H02S Circuit Slow Response (Bank 1/Sensor 1) >> Component Inspection

Component Inspection

  1. Check PCV.
    1. IG "OFF"
    2. Disconnect PCV.
    3. Check that PCV is properly operating.
    4. Is the PCV O.K?

      YES 

      • Go to step  2.

      NO 

      • Substitute with a known-good PCV and check for proper operation.
      • If the problem is corrected, replace PCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  2. Check the PCSV.
    1. Ignition "OFF".
    2. Disconnect PCSV and Vacuum Hose.
    3. Apply vacuum on PCSV with Hand Vacuum Gauge.
    4. Is the PCSV keeping the Vacuum?

      YES 

      • Go to step  3.

      NO 

      • Substitute with a known-good PCSV and check for proper operation. If the problem is corrected, replace PCSV and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  3. Check Injector.
    1. Ignition "OFF"
    2. Remove Injector.
    3. Check Leakage and clog on Injector.
    4. Measure resistance terminal 1 and 2 of Injector connector (Component side).
      RESISTANCE SPECIFICATION

      Temperature Resistance [Ω]
      20°C (68°F) 13.8-15.2Ω
      Fig 1: Measuring Resistance Terminal 1 And 2 Of Injector Connector
      G04862152Courtesy of KIA MOTORS AMERICA, INC.
    5. Is the measured resistance within specifications?

      YES 

      • Go to step  4.

      NO 

      • Substitute with a known-good Injector and check for proper operation. If the problem is corrected, replace Injector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  4. Check Sensors related to Fuel Trim.
    1. Check the Input Voltage of Sensors related to Fuel Trim (MAPS, TPS, ECTS, PCSV, Injector, and etc). Refer to Trouble Shooting Guide.
    2. Are the sensors related to Fuel Trim O.K?

      YES 

      • Go to step  5.

      NO 

  5. Check ECM/PCM.
    1. IG "OFF" and disconnect B1S1 connector.
    2. Connect scan tool and Key "ON".
    3. Select simulation function on scan tool.
    4. Simulate voltage at terminal 2 of HO2S (B1S1) sensor signal connector.
      Fig 2: Scan Tool Display - Simulate Voltage Of HO2S (B1/S1)
      G04862147Courtesy of KIA MOTORS AMERICA, INC.
    5. Is the HO2S (B1/S1) signal value changed according to simulation voltage?

      YES 

      • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Substitute with a known-good ECM/PCM and check for proper operation.
      • If the problem is corrected, replace ECM/PCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NOTE: There is a memory reset function on scan tool that can erase optional parts automatically detected and memorized by ECM/PCM.
Before or after testing ECM/PCM on the vehicle, use this function to reuse the ECM/PCM