LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rio Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0108 Manifold Absolute Pressure/Barometric Pressure Circuit High Input >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check open in harness.
    1. IG "OFF".
    2. Disconnect MAPS connector.
    3. IG "ON" & ENG "OFF"
    4. Measure voltage terminal 1 of MAPS harness connector and chassis ground.

      Specification : Approx. 5V

      Fig 1: Measuring Voltage Terminal 1 Of MAPS Harness Connector And Chassis Ground
      G06130122Courtesy of KIA MOTORS AMERICA, INC.
    5. Is the measured resistance within specification?

      YES 

      • Go to " 2" as follows.

      NO 

  2. Check short to battery in harness.
    1. IG "OFF".
    2. Disconnect MAPS and ECM connector.
    3. Measure resistance between terminal 1 and 2 MAPS harness connector.

      Specification : Infinite

      Fig 2: Measuring Resistance Between Terminal 1 And 2 MAPS Harness Connector
      G06130131Courtesy of KIA MOTORS AMERICA, INC.
    4. Is the measured resistance within specification?

      YES 

      NO