Removal And Installation
- Remove front pillar trim.
- Remove front door opening weatherstrip.
- Remove front pillar trim blanking cover.
- Remove front pillar trim screw (1).
- Remove center pillar lower trim.
- Remove front door scuff trim.
- Remove rear door scuff trim.
- Remove rear door opening weatherstrip.
- Remove center pillar lower trim.
- Remove center pillar upper trim.
- Remove front seat belt upper anchor bolt (1).
Tightening torque: 40-55 N.m (4.0-5.5 kg.m, 28.9-39.8 lb.ft)
- Remove center pillar upper trim blanking cover.
- Remove center pillar upper trim screws (2).
- Unfasten center pillar upper trim from body frame.
- Remove front seat belt upper anchor bolt (1).
- Remove rear pillar trim.
- Remove rear pillar trim blanking cover.
- Remove rear pillar trim screw (1).
- Remove sunvisor (LH).
- Remove sunvisor pivot mounting cover, and then remove sunvisor screws (2).
- Disconnect sunvisor connector.
- Remove sunvisor clamp screw (1), and then remove sunvisor clamp.
- Remove sunvisor (RH).
- Remove assist handle.
- Remove assist handle bolts (2).
- Remove over head console lamp.
- Remove overhead console lamp from roof trim.
- Disconnect overhead console lamp connector.
- Remove room lamp.
- Remove room lamp lens with screwdriver.
- Remove room lamp bolts (2).
- Disconnect room lamp connector.
- Remove headlining assembly.
- Remove headlining fasteners (3).
- Disconnect headlining connector.
- Install in reverse order of removal.