LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Magentis 2.4 3 >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Immobilizer Control System >> DTC Codes >> DTC P1690 SMARTRA No Response >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check for open in harness
    1. Ignition "OFF"
    2. Disconnect SMARTRA.
    3. Measure resistance between terminal "5" of SMARTRA and terminal C01-75 (2.0/2.4) or C201-1-45 (2.7) or C301-2-47 (Diesel)

      Specification: 1 Ω or less

      [2.4] 

      Fig 1: Measuring Resistance Between Terminal "5" Of SMARTRA And Terminal C01 (2.4L)
      G04806675Courtesy of KIA MOTORS AMERICA, INC.

      [2.7] 

      Fig 2: Measuring Resistance Between Terminal "5" Of SMARTRA And Terminal C01 (2.7L)
      G04806676Courtesy of KIA MOTORS AMERICA, INC.
    4. Is the measured resistance within specifications?

      YES  : Go to step  2.

      NO  : Check for open in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check for short in harness
    1. Ignition "OFF"
    2. Disconnect SMARTRA.
    3. Ignition "ON" & Engine "OFF"
    4. Measure voltage value between terminal "5" of SMARTRA and chassis ground.

      Specification: Approx. 5.48V

      Fig 3: Measuring Voltage Value Between Terminal "5" Of SMARTRA And Chassis Ground
      G04806677Courtesy of KIA MOTORS AMERICA, INC.
    5. Is the measured voltage within specifications?

      YES  : Go to "SIGNAL CIRCUIT INSPECTION " procedure

      NO  : Check for short in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.